![]() I am in desperate need of help.īalevre-sounds like quite a problem. I am not quite a newcomer to DCC but I am not quite advanced. So my question is, can ANYONE help me? What am I doing wrong? Does anyone have ANY suggestions? Any and I mean any advice is welcomed with open arms. I tried to use some computer software to edit/read my CVs and could not figure out how to make the software and my DCC controller work. ![]() I purchased one and hooked it up to the command station and attempted to program the loco and the loco STILL did not accept the program command and still is not working with the command station. I then read about needing a Program track booster. I then went to place the loco on the program track and attempted to reset the decoder, and the loco did nothing and did not respond to the programming. So, I figured I needed to reset the decoder. But I can not turn the lights on, move the loco, or sound the horn. However, I began to read in the manual about adjusting speed curves to speed match and ended up editing CV 29 to 18 then to 6 to allow for this adjustment and crashed my decoder ( So it feels.) The loco will NO LONGER respond to any command under any address I have given it whether 2 digit or 4 digit, BUT upon placing the loco on the powered MAIN line, the loco starts up and goes to idle. It ran perfectly out of the box on with my MRC Prodigy Express DCC controller. ![]() I bought the loco in used-like new condition. I have a Tsunami Soundtraxx decoder in an Athearn SD70MAC Alaska loco. I am have an extremely irritating problem and need some advice from much experienced DCC programmers:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |